TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 716 of 772
TM 9-2350-260-20-1-2 TURBOCHARGER SHROUDS REPLACEMENT (Sheet 2 of 6) Inner Shroud Replacement NOTE Procedures for replacement of the left or right turbocharger shrouds are similar. Procedures for the left side are shown. REMOVAL: 1. Using 11/16 inch wrench, disconnect hose assembly (A) from turbocharger elbow (B). 2. Using 1/2 inch socket, remove two screws and washers (C) securing inner shroud (D) to turbocharger plate. 3. Using 1/2 inch socket, remove two screws and washers (E) securing inner shroud (D) to turbocharger plate. 4. Using 1/2 inch wrench and 1/2 inch socket, remove screw and self-locking nut (F) securing inner shroud (D) to upper shroud (G). Throw self- locking nut away. 5. Using 1/2 inch socket, remove three screws and washers (H) securing inner shroud (D) to oil cooler frame. 6. Remove hose assembly (A) and grommet (J) from inner shroud (D). 7. Remove inner shroud (D). 8. Remove grommet (J) from hose assembly (A). Throw grommet away. Go on to Sheet 3 TA146861 9-14