TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 701 of 772
TM 9-2350-280-20-1-2 EXHAUST PIPE (RIGHT SIDE) REPLACEMENT (Sheet 3 of 4) INSTALLATION: 1. Position packing (A) and clamp (E) onto pipe (C) and, using flat-tip screwdriver, tighten screw on clamp (B) securing packing to pipe (C). 2. Check insulation halves (D) and all attaching hardware for damage. Replace if necessary. 3. Position insulation halves (D) onto exhaust pipe (C). 4. Using 5/16 inch wrench and cross-tip screwdriver, install 14 screws (E), each with two flat washers (F), one new lockwasher (G), and one nut (H) to hold insulation halves D) to exhaust pipe (C). 5. Position new gasket (J) onto turbosupercharger housing (K). 6. Position exhaust pipe (C) with installed insulation halves (D) onto turbosupercharger housing (K). Make sure exhaust port (L) is pointing up. 7. Using 9/16 inch socket and 7/8 inch wrench, install six new self-locking nut (M) securing exhaust pipe to housing. Go on to Sheet 4 TA146427 8-11