TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 70 of 772
TM 9-2350-260-20-1-2 2A ENGINE AND 2D ENGINE POWERPLANT TESTS (GROUND HOP) (Sheet 9 of 16) STALL TEST: NOTE This test is performed only to determine engine power loss or transmission slippage. NOTE Before performing stall test, check brake adjustment (page 13-2) 1. Adjust brakes (page 13-2). 2. Remove brake lever assembly from each side of transmission (page 13-91). 3. Install long brake apply levers (A) supplied with stall check it. 4. Using 3/4 inch wrench, remove two nut and lockwashers (B) from transmission. 5. Using nuts and lockwashers removed in step 4, install brake stall check tool (D) to transmission. 6. Using 3/4 inch wrench, tighten two nut and lockwashers (B). CAUTION Rotation of retainer (E) should be limited to one-half turn. 7. Using alien wrench, turn brake apply screw (C) in clockwise direction until retainer (E) begins to turn. Brakes will then be applied to preset loading. Go on to Sheet 10 TA147960 U.S. GOVERNMENT PRINTING OFFICE: 1986 - 642-089 5-60 Change 1