Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download

Page 681 of 772

TM 9-2350-260-20-1-2 ACCELERATOR FLANGE ASSEMBLY REPLACEMENT (Sheet 3 of 4) 7. Using 9/16 inch wrench, remove two nuts (G) and lockwashers (H) from flange assembly (J) and mounting stud (K). Throw lockwashers away. 8. Slide flange assembly (J) off end of rod assembly. INSTALLATION: 1. Using fingers, slide flange assembly (A) over rod assembly (B) onto mounting studs (C). 2. Using 9/16 inch wrench, install two new lockwashers (D) and nut (E) o mounting studs (C). 3. Using fingers, turn nut (1) o rod assembly (B). 4. Using 7/16 inch wrench, install rod end (G) on rod assembly (B). Turn rod end (G) until holes in rod end (G) and rod assembly (B) are alined. 5. Using 1/2 inch wrench, tighten nut (F) on rod assembly (B) against rod end (G). Go on to Sheet 4 TA148518 7-412