TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 677 of 772
TM 9-2350-260-20-1-2 ACCELERATOR TUBE ASSEMBLY REPLACEMENT (Sheet 3 of 41 CLEANING AND INSPECTION: 1. Clean all parts, using dry cleaning solvent (Item 54, Appendix D) and clean rags. 2. Inspect all parts for bends, cracks, stripped threads, wear, or other defects. Replace defective parts. INSTALLATION: 1. Install flat washer (A), spring (B), and clamp (C) on tube (D) with clamp (C) on pencil mark on tube (D). 2. Using 7/16 Inch wrench, install screw (E) and new lockwasher (F) in clamp (C). 3. Screw jamnut (G) all the way on tube (D). 4. Screw clevis (H) on tube (D) the recorded number of turns. 5. Using torque wrench and crowfoot, tighten jamnut (G) against clevis (H) to 13-15 lb-ft (1820 N•m) while holding clevis (H) with pliers. Go on to Sheet 4 TA148515 7-408