TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 676 of 772
TM 9-2350-260-20-1-2 ACCELERATOR TUBE ASSEMBLY REPLACEMENT (Sheet 2 of 4) 3. Using 1/2 inch wrench, loosen nut (D) from clevis (C). 4. Using pencil, mark location of clamp (E) on tube (F). 5. Using 7/16 inch wrench, remove screw (G) and lockwasher (H) from clamp (D). Throw lockwasher away. NOTE Count and write down number of turns needed to unscrew clevis (C). 6. Unscrew clevis (C) and nut (D) from tube (F). 7. Using pliers, remove cotter pin (J) from pin (K). Throw cotter pin away. 8. Remove pin (K) from clevis (L). 9. Pull tube (F) toward rear of tank and remove tube (F). 10. Remove clamp (E), spring (M), and fiat washer (N) from tube (F). 11. Using crowfoot, loosen jamnut (P) while holding clevis (L) with pliers. NOTE Count and write down number of turns needed to unscrew clevis (L). 12. Unscrew clevis (L) and jamnut (P) from tube (F). Go on to Sheet 3 TA148514 7-407