TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 669 of 772
TM 9-2350-260-20-1-2 ACCELERATOR LEVER ASSEMBLY REPLACEMENT (Sheet 2 of 3) 7. Remove washer bearing (N) from support (M). 8. Using socket, remove two screws (P), lockwashers (Q), and cable clamp (R). Throw lockwashers away. 9. Remove support (M) from tank. 10. Inspect bearing in lever (L). If bearing is defective, use hammer and drive pin punch and drive bearing out of lever (L). CLEANING AND INSPECTION: 1. Clean all parts using dry cleaning solvent (Item 54, Appendix D), and clean rags (Item 65, Appendix D). 2. Inspect al parts for cracks, bends, wear, and other defects. INSTALLATION: 1. Line up holes in bracket (A), clamp (B), and support (C). 2. Using fingers, install two screws (D) and new lockwashers (E) in bracket (A), clamp (B), and support (C). 3. Install washer bearing (F) on support (C). Go on to Sheet 3 TA148507 7-400