TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 660 of 772
TM 9-2350-260-20-1-2 ACCELERATOR PEDAL REPLACEMENT (Sheet 1 of 4) TOOLS: 9/16 in. combination box and open end wrench (2 required) 7/16 in. combination box and open end wrench Slip joint pliers 1/8 in. drive pin punch SUPPLIES: Paper tags Pencil Cotter pi (MS24665-281) Bearings (7765216) 2 required) Lockwasher (MS35338-46) (6 required) PRELIMINARY PROCEDURE: Remove accelerator foot pedal lock assembly (page 7-388) REMOVAL: NOTE Tag shims which may be located under housings (L) and (M) for installation. 1. Using 7/16 inch wrench, remove screw and lockwasher (A) securing detent plate (B). Throw lockwasher away. 2. Remove detent plate (B) from shaft (C). 3. Using 9/16 inch wrench, remove six screws and lockwashers (). Throw lockwasher away. 4. Remove bracket (E). 5. Remove cover (F). 6. Using pliers, remove cotter pin (G) from pin (H). Throw cotter pin away. 7. Remove pin (H) from lever (J) and clevis (K). 8. Remove pedal (P), control rod (C), and attached parts from tank as a unit. Go on to Sheet 2 TA148466 7-391