Sign up to sell your inventory with NSN Lookup

TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download

Page 651 of 772

TM 9-2350-260-20-1-2 ACCELERATOR LINKAGE ADJUSTMENT (Sheet 7 of 8) 43. Stop engine (TM 9-2350-260-10). 44. Insert either end of go/nogo gage (AB) between stop pin (AF) and bracket (AG). Hold in this position while person in driver's station presses pedal to full throttle position. 45. With pedal in full throttle position, screw (AH) must contact floor and stop pin must contact either end of go/no-go gage (AB). If this requirement cannot be met, do steps 46 thru 48. If requirement is met, go to step 49. 46. Using two 9/16 inch wrenches, loosen jamnut (AJ) and screw (AH) on back side of accelerator pedal (AK). 47. Using two 9/16 inch wrenches, hold screw (AH) and tighten jamnut (AJ). Go on to Sheet 8 TA148457 7-382