TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 650 of 772
TM 9-2350-260-20-1-2 ACCELERATOR LINKAGE ADJUSTMENT (Sheet 6 of 8) 35. Traverse turret to position gun tube to rear for entry to driver's station (TM 9-2350-260-10). 36. Remove locating pin (L) from remote control lever (M). 37. Traverse turret to position gun tube to front for access to engine compartment (TM 9-2350-260- 10). 38. Have one person in driver's station ready to start engine and watch tachometer while the other person measures accelerator travel at engine. 39. Start engine (TM 9-2350-260-10). 40. Using fabricated go/no-go gage (AB) (Figure F-3, Appendix F), measure for at least 1/8 inch clearance at idle speed 700 to 750 rpm. If idle adjustment is necessary, perform steps 41 and 42. If adjustment is not necessary, go on to step 43. 41. Using 1/2 inch wrench, loosen nut (AD). Adjust idle adjustment screw (AE) t the requirements of step 40. If requirements are met, go to step 42; if requirements cannot be met notify support maintenance. 42. Using 1/2 inch wrench, hold idle adjustment screw (AE). Using 1/2 inch wrench, tighten nut (AD). Go on to Sheet 7 TA148456 7-381