TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 647 of 772
TM 9-2350-260-20-1-2 ACCELERATOR LINKAGE ADJUSTMENT (Sheet 3 of 8) 10. Close turret platform access door. Traverse turret to position gun tube to rear for entry to driver's station (TM 9-2350-260-10). 11. Insert 1/8 inch diameter locating pin (L) through alinement hole of remote control lever (M). If locating pin cannot be inserted, perform steps 12 thru 17. If locating pin (L) can be inserted, go to step 18. 12. Using pliers, remove cotter pin and pin (N). Throw cotter pin away. 13. Using 1/2 inch wrench to hold clevis (P), use 1/2 inch wrench to loosen nut (Q). 14. Position remote control lever (M). Insert locating pin (L) from behind. NOTE If necessary, remove locator pin (L) and push remote control lever (M) forward to allow clevis (P) to turn. Then repeat steps 14 and 15. 15. Turn clevis (P) until pin (N) slips freely into remote control lever (M). 16. Using pliers, install new cotter pin through pin (N). 17. Using 1/2 inch wrench to hold clevis (P), use 1/2 inch wrench to tighten nut (Q). 18. Leave locating pin (L) in position until step 36. Go on to Sheet 4 TA148453 7-378