TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 646 of 772
TM 9-2350-260-20-1-2 ACCELERATOR LINKAGE ADJUSTMENT (Sheet 2 of 8) ADJUSTMENT’ 1. Open turret platform access door and traverse turret to position gun tube over right front fender stowage box (TM 9-2350-260-10). 2. Check to see that threaded shaft (A) is flush with inside of clevis (B) at location (C). If threaded shaft is flush, go to step 6. If threaded shaft is not flush, go to steps 3, 4, and 5. 3. Using pliers, remove cotter pin (D) and pin (E). Throw cotter pin away. 4. Using 9/16 inch wrench to hold clevis (B), use 1/2 inch wrench to loosen nut (F) and adjust clevis (B) so that shaft is flush with clevis. 5. Using 9/16 inch wrench to hold clevis (B), use 1/2 inch wrench to tighten nut (F). 6. Insert 1/16 inch diameter pin at location (G) in rod end bearing (H) to be sure that threads of tube assembly (J) go into rod end bearing beyond location (G). If tube assembly is not inserted beyond location (G), go to steps 7 and 8. If tube assembly is inserted beyond location (G), go to step 9. 7. Using 7/16 inch wrench to hold (on flats) rod end bearing (H) and 1/2 inch wrench to loosen nut (K), adjust rod end bearing as stated in step 6. 8. Using 7/16 inch wrench to hold (on flab) rod end bearing (H), use 1/2 inch wrench to tighten nut (K). NOTE Rod (H) or clevis (B) may be pulled in order to insert pin (E). 9. Insert pin (E) and, using pliers, install new cotter pin (D). Go on to Sheet 3 TA148452 7-377