TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 644 of 772
TM 9-2350-260-20-1-2 MANIFOLD HEATER FUEL FILTER, ELEMENT. AND INPUT FUEL LINE REPLACEMENT (Sheet 8 of 8) Fuel Filter Input Fuel Line Replacement (Sheet 1 of 1) TOOLS: 1/2 in. combination box and open end wrench 5/8 in. combination box and open end wrench SUPPLIES: Clean bucket or drip pan Plastic Tubing (7017826), 7.125 in. 1g. Nut (189894) (2 required) Sleeve (189911) (2 required) REFERENCE: TM 9-2350-260-10 PRELIMINARY PROCEDURE: Remove lower engine access cover (page 16-45) REMOVAL: CAUTION When removing or installing fuel lines, care must be taken not to damage fittings and threads or twist or distort fuel lines or hoses. NOTE Use suitable container to catch any fuel that may leak out whenever any part of fuel system is loosened or disconnected. 1. Using both wrenches, disconnect both ends of tube assembly (A) from adapters (B) and (C). 2. Remove tube assembly (A). INSTALLATION: 1. Make new tube assembly (A). 2. Position tube assembly (A) to adapters (B) and (C). 3. Using both wrenches, install tube assembly to adapters. 4. Operate primer pump (TM 9-2350-260-10) and check for leaks. If leak is found, tighten connection as required. 5. Install lower engine access cover (page 16-46). End of Task TA148450 7-375