TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 614 of 772
TM 9-2350-260-20-1-2 MANIFOLD HEATER (LEFT AND RIGHT BANK) FUEL RETURN TUBE ASSEMBLY REPLACEMENT (Sheet 4 of 7) 8. Using 9/16 inch wrench, remove line nut of tube assembly (C) from tee (K). 9. Using 9/16 inch wrench, remove line nut of tube assembly (L) from tee (K). 10. Using 5/16 inch wrench, remove two screws (M) and pull solenoid valve (N) forward approximately one inch. 11. Using 1/2 inch wrench on coupling (P), remove coupling with elbow and tee attached. 12. Using 9/16 inch wrench on elbow (O) and adjustable wrench on tee (K), remove tee (K) from elbow (Q). 13. Using 9/16 inch wrench on elbow (Q) and 1/2 inch wrench on coupling (P), remove elbow (Q) from coupling (P). 14. Push engine cooling fan shroud aside to allow clearance for removal of tube assembly (C). Other person, using both hands, carefully remove tube assembly (C) from engine. CLEANING AND INSPECTION: 1. Using clean rags and dry cleaning solvent (Item 54, Appendix D), clean fittings thoroughly. 2. Inspect fittings for nicks, cracks, thread damage, or wear. Replace if required. 3. Inspect internal threads of manifold heater and solenoid adapter for damage. Go on to Sheet 5 TA148420 7-345