TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 582 of 772
TM 9-2350-260-20-1-2 FUEL PRIMER INLET LINE TUBE ASSEMBLY REPLACEMENT (Sheet 3 of 5) 11. Using 11/16 inch wrench to hold nipple (S) and 5/8 inch wrench on nut T), remove nut (T). NOTE It may be necessary to slightly bend tube assembly (U) before it can be removed. 12. Remove tube assembly (U). CLEANING AND INSPECTION: 1. Clean tube assemblies and nut with rags (Item 65, Appendix D). 2. Inspect all parts for damage or wear. Replace any damaged or worn part. INSTALLATION: NOTE It may be necessary to slightly bend tube assembly (A) before it can be placed in position. 1. Place tube assembly (A) in position. 2. Start nut (B) on nipple (C) and leave finger tight. 3. Using two 5/8 inch wrenches, install nipple (D) in nut (E). 4. Position tube assembly (A) and clamp (F). 5. Using 7/16 inch wrench, install screw and lockwasher (G). 6. Using 5/8 inch wrench, tighten nut (B). Go on to Sheet 4 TA148388 7-313