TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 567 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR FILTER ELEMENT REPLACEMENT (Sheet 3 of 6) NOTE Do not remove or otherwise disturb the center element during outer filter element replacement unless all three elements are scheduled for replacement. 7. Using hands, remove two outer filter elements (J) by turning slightly and lifting out. Throw away filters. 8. Remove center filter element (K) in same manner as outer filters, if required. CLEANING AND INSPECTION: NOTE Take care when cleaning inside of fuel-water separator not to damage any internal parts. 1. Using dry cleaning solvent (Item 54, Appendix D) and rags, clean inside of fuel-water separator. 2. Inspect fuel-water separator for cracks or fractures. Inspect interior for scores and burrs. 3. Using dry cleaning solvent and crocus cloth (Item 14, Appendix D), remove minor burrs and scores. If cracked, excessively burred, or scored, contact your supervisor. 4. Flush with dry cleaning solvent. INSTALLATION: 1. Remove container from under fuel-water separator. 2. Remove rag from fuel outlet line (A). 3. Using 7/8 inch wrench, install fuel outlet line (A) to elbow (B). Go on to Sheet 4 TA148373 7-298