Sign up to sell your inventory with NSN Lookup

TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download

Page 564 of 772

TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE) (Sheet 8 of 8) 3. Set MASTER CONTROL switch to ON (TM 9- 2350-260-10). Watch fuel-water separator bleed cap (A) for air release (bubbles). 4. Set MASTER CONTROL switch to OFF (TM 9- 2350-260-10). After about one minute, repeat step 3. NOTE It may be necessary to perform steps 4 and 5 several times until a constant fuel flow (no bubbles) from the bleed cap (A) is observed. 5. Check for leaks and tighten or replace component as necessary. 6. Using 7/16 inch wrench, turn fuel-water separator bleed cap (A) to the right until snug. 7. Perform operational check of automatic drain (page 7-245). 8. Set FUEL PUMPS switch to OFF (TM 9-2350-260-10). 9. Set MASTER CONTROL switch to OFF (TM 9-2350-260-10). 10. Disconnect engine from powerplant ground hop (page 5-67). 11. Install powerplant (page 5-40). End of Task TA148370 7-295