TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 562 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE) (Sheet 6 of 8) CAUTION Be careful not to strike ends of sensors during installation or damage may result. NOTE Straight edge of mounting plate (G) must be installed to the right against the fuel-water separator. 5. Manually conned solenoid valve electrical lead (D) to fuel-water separator control assembly (A). 6. Manually connect engine electrical harness connector (E) to fuel-water separator control assembly (A). 7. Using screwdriver, install two screws and two cushioned clamps (F) and mounting plate (G) at right side and above fuel-water separator control assembly. 8. Using 9/16 inch wrench, install lower (shorter) sensor (H) to fuel-water separator filter. 9. Using 9/16 inch wrench, install upper (longer) sensor (J) to fuel-water separator filter. Go on to Sheet 7 TA148368 7-293