TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 561 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE) (Sheet 5 of 8) INSTALLATION: 1. Position three cushioned clamps into sensor leads from replaced fuel-water separator control assembly. 2. Position fuel-water separator control assembly (A) onto mounting plate. 3. Using 5/16 inch socket with extension, install three screws and washers (B). 4 Using 5/16 inch wrench, install screw and cushioned clamp (C) holding solenoid valve electrical lead D) to fuel-water separator control assembly (A). Go on to Sheet 6 TA148367 7-292