TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 560 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE) (Sheet 4 of 8) 12. Using screwdriver, remove two screws and two cushioned clamps J) and mounting plate (K) at right side and above fuel-water separator control assembly (L). NOTE It may be necessary to use pliers to start removal of connectors in steps 13 and 14. 13. Manually disconnect engine electrical harness connector (M) from fuel-water separator control assembly (L). 14. Manually disconnect solenoid valve electrical lead (N) from fuel-water separator control assembly (L). 15. Using 5/16 inch wrench, remove screw and cushioned amp (P) holding solenoid valve electrical lead (N) to fuel-water separator control assembly (L). 16. Using 5/16 inch wrench, remove three remaining screws and washers (Q) holding fuel-water separator control assembly (L) to mounting plate. Remove control assembly. Go on to Sheet 5 TA148366 7-291