TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 56 of 772
TM 9-2350-260-20-1-2 POWERPLANT REPLACEMENT (2D ENGINE) (Sheet 21 of 26) 30. Engage rod ends (use pliers if necessary) and manually install screw, new lockwasher, and nut (T) (each side of tank). 31. Using 7/16 inch socket on screw and 7/16 inch wrench to hold nut, tighten screw, lockwasher, and nut (T). 32. Manually position boot (R) and two clamps (Q) and using 5/16 inch wrench, tighten two damps (Q) (each side of tank). 33. Wearing rubber gloves, use rags (Item 65, Appendix D) and cleaning solvent (Item 54, Appendix D) to clean contact areas of brake rod access covers (U) and hull. 34. Apply adhesive (Item 2, Appendix D) to both sides of two new gaskets. Position two new gaskets onto inner side of two brake rod access covers (U). WARNING Support brake rod access covers (U) with hand to prevent personal injury. 35. Position left and right brake rod access covers (U) to hull. Manually install 12 screws and new lockwashers (V). 36. Using 9/16 inch socket, tighten 12 screws and lockwashers (V). Go on to Sheet 22 TA147947 5-46