TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 559 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (2D ENGINE) (Sheet 3 of 8) 8. Using 1/2 inch socket and extension, remove three capscrews, lockwashers, flat washers (D), and clamp (E). Throw lockwashers away. 9. Using 1/2 inch socket and extension, loosen capscrew (F) to provide movement to fuel-water separator filter. NOTE If adapters turn while removing sensors, use 1/2 inch wrench to hold them in place. 10. Using 9/16 inch wrench, remove upper sensor (G) from fuel-water separator filter. NOTE It may be necessary to use hammer and punch to unseat sensors (G) and (H) by tapping upward on the edge of the sensor retaining nut. 11. Using 9/16 inch wrench, remove lower sensor (H) fuel-water separator filter. Go on to Sheet 4 TA148365 7-290