TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 556 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR DRAIN LINES REPLACEMENT (2D ENGINE) (Sheet 6 of 6) 6. Install tee (F) into vise, and, using 11/16 inch wrench, install adapter (G) into tee (F). 7. Remove tee (F) and adapter (G) assembly from vise. 8. Position tee (F) and adapter (G) assembly into mounting bracket (H): 9. Using 11/16 inch wrench to hold adapter (G), use 11/16 inch wrench and install new lockwasher and nut (J) onto adapter (G). 10. Using adjustable wrench, install drain valve (K) into tee (F). 11. Position hose assembly (L) to adapter (G) and elbow (M). 12. Using 9/16 inch wrench, install hose assembly (L) to adapter (G) and elbow (M). 13. Using 9/16 inch wrench, install hose assembly (D) to tee (F). 14. Position clamp (N) onto hose assembly (L). 15. Using 9/16 inch wrench, install nut (P) to secure clamp (N). 16. Close drain valve (K) by turning clockwise. 17. Test fuel-water separator (page 7-262, steps 1 thru 11). 18. Install powerplant (page 5-40). End of Task TA149362 7-287