TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 553 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR DRAIN LINES REPLACEMENT (2D ENGINE) (Sheet 3 of 6) 6. Using 9/16 inch wrench, remove nut (D) securing damp (E). 7. Remove lamp (E) from hose assembly (F). 8. Using 9/16 inch wrench, disconnect hose assembly (F) from elbow (G). 9. Using 11/16 inch wrench to hold adapter (H), use 9/16 inch wrench and disconnect hose assembly (F) from adapter (H). 10. Remove hose assembly (F). 11. Using 9/16 inch wrench, disconnect hose assembly (J) from tee (K). 12. Using 5/8 inch wrench to hold tee (K), use adjustable wrench and remove drain valve (A). 13. Using 11/16 inch wrench to hold adapter H), use 11/16 inch wrench and remove nut (L). Tee (K) and adapter (H) will fall free when nut (L) is removed. Throw lockwasher (L) away. 14. Install tee (K) into vise, and, using 11/16 inch wrench, remove adapter (H) from tee (K). Go on to Sheet 4 TA148359 7-284