Sign up to sell your inventory with NSN Lookup

TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download

Page 550 of 772

TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR DRAIN SOLENOID VALVE REPLACEMENT (20 ENGINE) (Sheet 3 of 3) INSTALLATION: NOTE Coat all exposed threads of adapter and elbow with zinc-chromate primer (Item 50, Appendix D) before installing. 1. Using 9/16 inch wrench, install elbow and tube (A) to solenoid valve (B). 2. Using 9/16 inch wrench, install adapter (C) n solenoid valve (B). 3. Position solenoid valve (B) to bracket 4. Using 5/16 inch wrench, install two screws and new washers (D) to secure solenoid valve (B) to bracket. 5. Using two 9/16 Inch wrenches, connect hose assembly (E) to adapter (C). 6. Connect electrical lead (F) to solenoid valve (B). 7. Close drain valve (G) by turning valve handle clockwise. 8. Using 7/16 inch wrench, turn bleed cap (H) clockwise until snug. 9. Test fuel-water separator (page 7-245, steps 1 thru 11). 10. Install powerplant (page 5-40). End of Task TA148356 7-281