TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 547 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR CONTROL ASSEMBLY TO FUEL-WATER SEPARATOR DRAIN SOLENOID WIRING HARNESS REPLACEMENT (2D ENGINE) (Sheet 1 of 1) TOOLS: 5/16 in. combination box and open end wrench Slip-joint pliers PRELIMINARY PROCEDURE: Remove powerplant (page 5-27) REMOVAL: 1. Using wrench, remove screw and washer (A) from clamp (B). Remove clamp from harness (C). 2. Using pliers, disconnect harness (C) from control assembly (D) and drain solenoid (E), and remove harness from powerplant. INSTALLATION: 1. Connect harness (C) to control assembly (D) and drain solenoid (E) a shown. 2. Using pliers, tighten connectors on ends of harness (C). 3. Position clamp (B) around harness (C) a shown, being sure to place clamp around leads at control assembly. 4. Using wrench, install screw and washer (A) through clamp (B) into control assembly mount. 5. Install powerplant (page 540). End of Task TA148353 7-278