TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 530 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR FLUID PRESSURE FILTER REPLACEMENT (Sheet 6 of 7) 5. Using socket, install two capscrews, new lockwashers and fiat washers (E). 6. (2A engine). Install capscrew, new lockwasher, and flat washer (G) onto fuel-water separator filter (H). 7. (2D engine). Position clamp (F) around sensor wires (C) and (D) and, using socket, install capscrew, new lockwasher, flat washer (G), and clamp (F) onto fuel-water separator filter (H). 8. Using socket, tighten capscrew (B). 9. Using 9/16 inch wrench, install condensate drain line (J) to elbow (K). 10. Remove plastic barrier material and tape from opening of fuel inlet line (L) and elbow (M). 11. Using 7/8 inch wrench, install fuel line (L) to elbow (M). 12. Remove plastic barrier material and tape from openings of fuel outlet line (N) and elbow (P). 13. Using 7/8 inch wrench, install outlet line (N) to elbow (P). Go on to Sheet 7 TA148336 7-261