TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 528 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR FLUID PRESSURE FILTER REPLACEMENT (Sheet 4 of 7) 12. Using 7/16 inch wrench, turn bleed cap (K) counterclockwise until loose. Let fuel-water filter drain. 13. Using socket, remove three capscrews, lockwashers, and flat washers (L). Throw lockwashers away. 14. (2D engine). Remove clamp (M) from filter (C). NOTE It may be necessary to tap sensor just above threaded portion of adapter with 1/8 inch punch and hammer. 15. Using socket, loosen capscrew (N) to provide movement of fuel-water separator filter (C). NOTE Go to step 20 if you have a 2A engine. 16. Using 9/16 inch wrench, remove upper sensor (P) from fuel-water separator filter (C). 17. Tag upper sensor (P) to make sure of correct installation. 18. Using 9/16 inch wrench, remove lower sensor (Q) from fuel-water separator filter (C). 19. Tag lower sensor (Q) to make sure of correct installation. Go on to Sheet 5 TA148334 7-259