TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 525 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR FLUID PRESSURE FILTER REPLACEMENT (Sheet 1 of 7) PROCEDURE INDEX PROCEDURE PAGE Removal 7-257 Installation 7-260 Test 7-262 TOOLS: 1/2 in. socket with 1/2 in. drive 5 in. extension with 1/2 in. drive Ratchet with 1/2 in. drive 7/16 in. combination box and open end wrench 7/8 in. combination box and open end wrench 9/16 in. combination box and open end wrench Hammer 1/8 in. drive punch SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I) SUPPLIES: Drip pan Rags (Item 65, Appendix D) Masking tape (Item 57, Appendix D) Plastic barrier material (Item 41, Appendix D) Tags Lockwasher (MS35338-45) (4 required) REFERENCE: TM 9-2350-260-10 PRELIMINARY PROCEDURE: Remove powerplant (page 5-1) NOTE This procedure applies to fuel-water separator filters on 2A and 2D engines. Where there are differences in procedure, they are noted. The 2D engine is used to illustrate the procedures. Go on to Sheet 2 TA148331 7-256