TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 524 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR OPERATIONAL TESTS (2D ENGINE) (Sheet 11 of 11) 19. Using 7/16 inch wrench if required, close bleed cap (R) until snug by turning clockwise. 20. Using adjustable wrench, remove pipe plug from upper sensor hole (A). 21. Using 1/2 inch wrench, install sensor retaining nut (S). NOTE Upper sensor (E) is longer than lower sensor (F). 22. Using 1/2 inch wrench to hold sensor retaining nut (S), use 9/16 inch wrench and install upper sensor (E) into fuel-water separator (D). 23. Using adjustable wrench, remove pipe plug from lower sensor hole (T). 24. Using 1/2 inch wrench, install sensor retaining nut (U). 25. Using 1/2 inch wrench to hold sensor retaining nut (U), use 9/16 inch wrench and install lower sensor (F) into fuel-water separator (D). 26. Position clamp (V) onto fuel-water separator and, using 1/2 inch socket, install three capscrews, new lockwashers, and flat washers (W). 27. Using 1/2 inch socket, tighten capscrew (X). 28. Install powerplant (page 5-40). 29. Purge fuel system (page 7-10). End of Task TA148330 7-255