TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 523 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR OPERATIONAL TESTS (2D ENGINE) (Sheet 10 of 11) 11. Remove tip of lower (F) sensor probe from water in metal container (G) before 15 seconds have gone by from time of putting it in and check if fluid stops draining from solenoid drain valve drain tube (J). 12. If fluid does not start draining (step 9), does not keep draining (step 10), or does not stop draining (step 11), refer to troubleshooting procedures (page 4-256). 13. Disconnect cable (Figure F-7, Appendix F) from both terminals of power source (K). 14. Disconnect connector (L) at fuel-water separator control box (M). 15. Disconnect cable (N) (Figure F-8, Appendix F) from power source (K). 16. Disconnect cable (N) (Figure F-8, Appendix F) from metal container (G). 17. Remove metal container (P) from under solenoid drain valve drain tube (J). 18. Using pliers, connect engine electrical harness connector (Q) to fuel-water separator control box (M) by turning clockwise. Go on to Sheet 11 TA148329 7-254