TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 517 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR OPERATIONAL TESTS (2D ENGINE) (Sheet 4 of 11) AUTOMATIC DRAIN TEST: 1. Place metal container (A) under solenoid drain valve drain tube (B). 2. Using pliers, disconnect engine electrical harness connector (C) from fuel-water separator control box (D) by turning counterclockwise. 3. Fill metal container (E) with water. 4. Connect cable (Figure F-8, Appendix F) from negative (-) terminal of power source (F) to metal container (E). 5. Connect connector (G) of cable (Figure F-7, Appendix F) to fuel water separator control box. WARNING Do not let upper (H) and lower (J) sensor probes come in contact with each other or with bottom or side of metal container (E). When moving sensor probes, do so by holding insulated cables (K) and (L). Do not touch probes (H) or (J) with hands. 6. Connect red wire of cable to positive terminal of power source (F). 7. Connect black wire of cable to negative (-) terminal of power source (F). Go on to Sheet 5 TA148323 7-248