TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 516 of 772
TM 9-2350-260-20-1-2 FUEL-WATER SEPARATOR OPERATIONAL TESTS (2D ENGINE) (Sheet 3 of 11) 11. Using 1/2 inch wrench, remove sensor retaining nut (J). 12. Using adjustable wrench, install pipe plug into lower sensor probe (C) hole. 13. If fuel did not leak from upper sensor (B) hole, use adjustable wrench to remove pipe plug from upper sensor (B) hole and go to step 14. If fuel did leak from upper sensor (B) hole, go to step 18. 14. Using 7/16 inch wrench, remove eight screws, lockwashers, and flat washers (K) securing cover (L) to separator (A). Remove cover (L) from separator (A). Throw lockwashers away. 15. Remove preformed packing (M) from cover (L). Throw packing away. 16. Add fuel to fuel-water separator (A) until fuel leaks from upper sensor (B) hole. 17. Using adjustable wrench, install pipe plug in upper sensor (B) hole. 18. Place cover (L) in position and, using 7/16 inch wrench, install eight screws, lockwashers, and flat washers (K). 19. Using 7/16 inch wrench, open bleed cap (H) by turning counterclockwise. 20. Place metal container (M) under outlet of manual drain valve (N). 21. Open manual drain valve (N) by turning petcock (P) counterclockwise. Allow small amount of fluid to drain into metal container (M), and then dose manual drain valve (N). 22. If fluid does not drain, refer to troubleshooting procedure (page 4-256). 23. If fluid does drain, go on to automatic drain test on next page. Go on to Sheet 4 TA148322 7-247