TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 494 of 772
TM 9-2350-260-20-1-2 FUEL RETURN HOSE (RIGHT FUEL TANK) REPLACEMENT (Sheet 2 of 2) NOTE Put rags under each connection before removing hose end fittings. REMOVAL: 1. Using socket, loosen and remove screw and lockwasher (A) from hose clamp (B). Throw lockwasher away. 2. Using 1-7/16 inch wrench on hose and fitting (C), and 1-1/2 inch wrench on fitting (D), hold hose at point (C) while loosening fitting (D) away from hose and fitting (C). 3. Using 1-7/16 inch wrench, loosen fitting (with hose) (E). Remove hose. INSTALLATION: 1. Lightly coat threads of both male hose ends with sealing compound (Item 24, Appendix D). 2. Using 1-7/16 inch wrench, secure fitting (with hose) (A). 3. Using socket, secure clamp (B) with screw and new lockwasher (C). 4. Using 1-7/16 inch wrench on hose and fitting and 1-1/2 inch wrench on fitting (E), hold hose at point (D) while securing fitting (E). 5. Ground hop engine (page 5-54) and allow it to run for brief time while checking for leaks (page 5-65). If leak is detected, stop engine and tighten fitting. If fittings do not leak, disconnect ground hop kit (page 5-67). 6. Install 2A powerplant (page 5-14) or 2D powerplant (page 5-40). 7. Fill fuel tanks. End of Task TA148300 7-25