TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 433 of 772
TM 9-2350-260-20-1-2 FUEL TANK (RIGHT) FILLER REPAIR (Sheet 5 of 6) INSTALLATION: 1. Install strainer (A) in fuel tank (B). 2. Install filler neck (C) on fuel tank (B). 3. Using screwdriver, secure filler neck (C) to fuel tank (B) using eight screws (D). 4. If required, use slip joint pliers and install lockwire (Item 59, Appendix D) (E) in eight screws (D). 5. Using two new gaskets (F) and new washers (G), assemble seal assembly (H) and install eight new screws (J) finger tight 6. Install seal assembly (H) on filler neck. While holding filler neck in position, use screwdriver and tighten screws (J) until gaskets (F) and (G) are compressed to form tight seal between filler neck and hull. Go on to Sheet 6 TA148239 7-164