TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 391 of 772
TM 9-2350-260-20-1-2 AIR CLEANER (ALUMINUM AND SIDE LOADING) BLOWER FAN HOSE REPLACEMENT (Sheet 1 of 1) TOOLS: Flat-tip screwdriver SUPPLIES: Silicone compound (Item 32, Appendix D) PRELIMINARY PROCEDURES: Remove air cleaner cover and gasket (page 7-131, steps 1 thru 3) Remove air cleaner blower fan, if necessary (page 7-125) NOTE Aluminum air cleaner shown. Procedure for side loading air cleaner is similar. REMOVAL: 1. Using screwdriver, loosen two clamps (A). 2. Slide clamps (A) onto hose (B). 3. Remove hose (B) from blower fan (C) and housing (D). 4. Inspect hose (B) and clamps (A). Replace as necessary. INSTALLATION: 1. Position clamps (A) onto hose (B). 2. Coat inside diameter of hose ends with silicone compound (Item 32, Appendix D) and install hose (B) to blower fan (C) and housing (D). 3. Slide clamps (A) to ends of hose. Using screwdriver, tighten clamps (A). 4. Install air cleaner blower fan, if required (page 7-129). 5. Install air cleaner cover and gasket (page 7-133, steps S thru 5). End of Task TA148197 7-122