TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 37 of 772
TM 9-2350-260-20-1-2 POWERPLANT REPLACEMENT (2D ENGINE) (Sheet 2 of 26) PRELIMINARY PROCEDURES Park tank on level ground. Block both tracks at front and rear Release paring brake (TM 9-2350-260-10) Place MASTER CONTROL switch to OFF (TM 9-2350-260-10) Disconnect battery ground straps (page 10-294) Remove upper engine access cover (page 16-44) Remove top deck (page 16-20) Remove transmission shroud (page 9-20) REMOVAL: 1. Using 7/16 inch wrench, remove six screws (A) holding generator air duct (B) to bulkhead wall. 2. Fasten generator air duct (B) to engine with heavy masking tape (Item 57, Appendix D) to prevent damage during powerplant removal. Go on to Sheet 3 TA147928 5-27