TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 352 of 772
TM 9-2350-260-20-1-2 AIR CLEANER INTAKE AND HOSE REPLACEMENT (Sheet 2 of 5) REMOVAL: 1. Using wrench, loosen clamp nut (A) at end of intake hose (B). 2. Slide clamp (C) over intake hose (B) to middle of hose. 3. Using screwdriver, pry hose (B) from elbow (D) and remove clamp (C). 4. Close grille doom and go inside turret. 5. Traverse turret to gain access to air intake. 6. (Early M60). Using 1/2 inch socket remove four assembled screws and washers (E). Throw screws away. 7. (Late M60). Using 1/2 inch socket, remove four screws and lockwashers (E). Throw lockwashers away. 8. Remove cover and gasket (F). 9. Inspect gasket cemented to cover (F). If damaged, use putty knife and remove gasket. Apply adhesive (Item 2, Appendix D) to new gasket and potion onto cover. 10. Using 9/16 inch socket, remove eight nut and lockwashers (G). Throw lockwashers away. 11. Remove air intake flange assembly (H) and hose. 12. Inspect gasket (J) cemented to bulkhead. If damaged, use putty knife and remove gasket. Apply adhesive (Item 2, Appendix D) to new gasket (J) and position on bulkhead. Go on to Sheet 3 TA148158 7-83