TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 338 of 772
TM 9-2350-260-20-1-2 PERSONNEL HEATER FUEL PUMP REPLACEMENT (Sheet 3 of 3) INSTALLATION: 1. Using 1/2 inch wrench, install elbow (A) into pump (B). 2. Using 7/16 inch wrench, install elbow (C) into pump (B). NOTE When installing heater pump, make sure cable condenser bracket is secured with pump mounting bracket. NOTE Be sure elbows (A) and (C) are alined with the chalk marks on the pump. 3. Mount condenser bracket and fuel pump (B) to plate. Using fingers, install two screws (D) and flat washers (E). 4. Install two new lockwashers (F) and nuts (G) to other side of mounting plate. 5. Using socket, tighten screws (D) while holding nuts (G) with 7/16 inch open end wrench. 6. Using 5/8 inch wrench, connect and tighten nut (H) to connect hose (J) to 45° elbow. 7. Using 9/16 inch wrench, connect and tighten nut (K) of tube (L) to 90° elbow. 8. Plug electrical connector (M) to harness (N). 9. Operate personnel heater (TM 9-2350-260-10). End of Task TA148144 7-69