TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 307 of 772
TM 9-2350-260-20-1-2 ENGINE FUEL PUMP REPLACEMENT (Sheet 2 of 4) REMOVAL: 1. Using 13/16 inch wrench on adapter (A) and 7/8 inch wrench on line nut (B), remove hose assembly (C). 2. Using 3/4 inch wrench on adapter (D) and 7/8 inch wrench on line nut (E), loosen line nut (E). 3. Using 3/4 inch wrench, loosen adapter (D) 1/2 turn. Do not remove adapter (D) at this time. 4. Using 1/2 inch wrench to hold adapter (F) and 5/8 inch wrench on hose fitting (G), loosen fitting (G). 5. Using fingers, pull hose assembly (H) loose from adapter (F). 6. Using 1/2 inch wrench, remove adapter (F). 7. Using 3/4 inch wrench on adapter (J) and 7/8 inch wrench on line nut (K), loosen line nut (K). 8. Using 13/16 inch wrench, remove adapter (A). 9. Using 1/2 inch wrench, remove four self-locking nut (L) and washers (M) from mounting studs (N). Throw self-locking nut away. 10. Using both hands, carefully remove fuel pump (P) from mounting studs (N). Tube (Q) will disconnect. 11. Remove tube (Q). 12. Using 3/4 inch wrench, remove adapter (D). 13. Using fingers, remove gasket (R) from mounting studs (N). 14. Throw gasket (R) away. Go on to Sheet 3 TA148113 7-38