TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 304 of 772
TM 9-2350-260-20-1-2 TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW) REPLACEMENT (Sheet 4 of 5) 2. Using fingers, install bulkhead elbow (C) in hole in front side of engine bulkhead. 3. Using 3/4 inch wrench to hold bulkhead elbow (C) and 1 inch wrench, install flat washer (D), new lockwasher (E), and nut (F), on bulkhead elbow (C). 4. Using 3/4 inch wrench, turn bulkhead elbow (C) until alined with hose assembly (G). Tighten nut (F). 5. Using 1 inch wrench to hold nut (F) and 7/8 inch wrench, install tube assembly (A) on bulkhead elbow (C). 6. Using 7/8 inch wrench, install hose assembly (G) on bulkhead elbow (C). Go on to Sheet 5 TA148110 7-35