TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 303 of 772
TM 9-2350-260-20-1-2 TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW) REPLACEMENT (Sheet 3 of 5) 7. Using 7/8 inch wrench, remove tube assembly (C) from fuel injection pump adapter (G). 8. Using fingers, remove tube assembly (C) from tank. CLEANING AND INSPECTION: 1. Using rags (Item 65, Appendix D) and dry cleaning solvent (Item 54, Appendix D), clean elbow and tube assembly mounting hardware thoroughly. Using wire brush, clean threaded parts. 2. Inspect elbow and tube assembly mounting hardware for bends, breaks, rounded edges, wear, or thread damage. Replace if required. 3. Inspect adapter on fuel injection pump for thread damage. INSTALLATION: NOTE Coat pipe threads of fittings with sealing compound (Item 27, Appendix D) before installation. 1. Using 7/8 inch wrench, install tube assembly (A) on fuel injection pump adapter (B). Go on to Sheet 4 TA148109 7-34