TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 302 of 772
TM 9-2350-260-20-1-2 TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW) REPLACEMENT (Sheet 2 of 5) NOTE Use drain pan and rags to catch fuel in hose and tube assemblies. REMOVAL: 1. Using 7/8 inch wrench, remove hose assembly (A) from bulkhead elbow (B). 2. Using 1 inch wrench to hold nut of bulkhead elbow (B) and 7/8 inch wrench, remove tube assembly (C) from bulkhead elbow (B). 3. Using 3/4 inch wrench to hold bulkhead elbow (B) and 1 inch open end wrench, remove nut, lockwasher, and flat washer (D) from bulkhead elbow (B). Throw lockwasher away. 4. Remove bulkhead elbow (B) from engine bulkhead. 5. Using 3/8 inch wrench and screwdriver, remove three screws and self-locking nuts (E) from tube clamps (F). Throw self-locking nuts away. 6. Using fingers, remove three tube clamps (F) from tube assembly (C). Go on to Sheet 3 TA148108 7-33