TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 30 of 772
TM 9-2350-260-20-1-2 POWERPLANT REPLACEMENT (2A ENGINE) (Sheet 19 of 24) 33. Position angle bracket (S) to rear side wall (by powerplant guide). Hang tab of bracket onto tab on compartment side wall. 34. Install three screws (T), new lockwashers (U), and washers (V) to secure angle bracket (S) to side wall (both sides). 35. Using 9/16 inch socket, tighten three screws (T) (both sides) to secure bracket (S) to side wall. NOTE Before connecting brake rod ends, make sure two clamps (W) are on each boot (X). NOTE If your tank has a spring loaded sleeve type disconnect, perform step 36. If it has screw, lockwasher, and nut type, go to step 37. 36. Push sleeve (Y) forward, engage rod ends (use pliers if necessary), and push sleeve to rear to retain rod ends (each side of tank). Go on to step 38. Go on to Sheet 20 TA147921 5-20