TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 270 of 772
TM 9-2350-260-20-1-2 OIL COOLERS - CLEANING (Sheet 3 of 3) 4. Squeeze lever (F) to obtain an air-liquid mixture and spray fins (E) with cleaning solution. Allow time for solution to soak between oil cooler fins. 5. Clean oil coolers by alternately moving cleaner head (D) from left to right and up and down. Cleaning solution flows freely through entire oil cooler area. NOTE If oil coolers were cleaned with powerplant installed, use hose and water to make sure oil cooler screens are clear. 6. When oil cooler fins (E) are clean, use hose to flush with water. 7. Dry all parts with air by removing end of siphon hose (B) from cleaning solution container (C) and squeezing lever (F). 8. Remove engine opening protective coverings. 9. Close hull drains (TM 9-2350-260-10). 10. Install engine access covers (2A engine, pages 6-78 and 6-86) (2D engine, pages 6-82 and 6-91). 11. Install engine shroud (page 9-3). 12. Install screens, if removed (pages 6-117 and 6-119). 13. Install top deck (page 16-22). End of Task TA147639 6-193/(6-194 blank)