TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 260 of 772
TM 9-2350-260-20-1-2 ENGINE TO TRANSMISSION OIL LINE TUBE ASSEMBLIES (RIGHT INNER AND OUTER) REPLACEMENT (2D ENGINE) (Sheet I of 4) PROCEDURE INDEX PROCEDURE PAGE Removal 6-184 Installation 6-185 TOOLS: 1-1/2 in. open end wrench 1-5/8 in. open end wrench SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I) SUPPLIES: Drip pan Masking tape (Item 57, Appendix D) Plastic barrier material (Item 41, Appendix D) Rag (Item 65, Appendix D) Gasket (MS35769-31) (4 required) REFERENCE: LO 9-350-260-12 PRELIMINARY PROCEDURES: Remove powerplant (page 5-25) Remove engine shroud (page 9-2) Remove rear engine shroud support (page 9-4) Go on to Sheet 2 TA147629 6-183