TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 256 of 772
TM 9-2350-260-20-1-2 ENGINE TO TRANSMISSION OIL LINE TUBE ASSEMBLIES (INNER AND OUTER) REPLACEMENT (2A ENGINE) (Sheet 2 of 5) REMOVAL: NOTE Tag oil cooler tubes as they are removed for later installation. Removal of left and right side oil cooler tubes is the same. 1. Using 1-5/8 inch wrench, hold two adapters (A) one at a time and, using 1-1/2 inch wrench, loosen two jamnuts (B) one at a time. 2. Using 1-5/8 inch wrench, remove two adapters (A) and gaskets (C) from oil cooler (D). 3. Throw gaskets (C) away. NOTE Upon removing tubes and fittings, seal powerplant openings with plastic barrier material (Item 41, Appendix D) and masking tape (Item 57, Appendix D) to prevent unnecessary exposure to moisture and contamination. Remove plastic barrier material and masking tape when installing tubes and fittings. Go on to Sheet 3 TA147625 6-179