TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 238 of 772
TM 9-2350-260-20-1-2 THERMOSTATIC ENGINE OIL COOLER VALVE ASSEMBLY (LEFT AND RIGHT) REPLACEMENT (Sheet 4 of 4) INSTALLATION: NOTE If replacing valve assembly, the engine oil cooler bypass valve also must be replaced. Go to page 6-13 for replacement. 1. Install new spacer ring (B) on valve (A). 2. Seat threads of valve (A) in engine oil cooler socket (C) by hand. 3. Using wrench, tighten valve (B). 4. Replace left engine cooler (2A engine, page 6-125) (2D engine, page 6-131) (if required). 5. Connect engine oil return hose to fitting (2A engine, page 6-127, steps 18 and 19) (2D engine, page 6-132, steps 14 and 15). 6. Tighten engine oil drain valve (2D engine, page 6-133, step 17) (2D engine). 7. Tighten engine oil filter vent bolt (2D engine) (page 6-133, steps 18 and 19). 8. Check engine oil level indicator gage rod (TM 9-2350-260-10). 9. Replenish lubricating oil lost during valve assembly replacement. 10. Perform ground hop (page 5-57). 11. Install 2A powerplant (page 514) or 2D powerplant (page 5-40). End of Task TA147610 6-161