TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 235 of 772
TM 9-2350-260-20-1-2 THERMOSTATIC ENGINE OIL COOLER VALVE ASSEMBLY (LEFT AND RIGHT) REPLACEMENT (Sheet 1 of 4) PROCEDURE INDEX PROCEDURE PAGE Removal 6-159 Inspection 6-159 Test 6-160 Installation 6-161 TOOLS: 1-/4 in. open end wrench Ruler Low-pressure compressed air facility SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I) SUPPLIES: Cooking stove (mounted in tank) Drip pan 12 in. length of scrap wire Spacer ring (7403580) Pencil Sealing washer Paper REFERENCE: LO 923526512 PRELIMINARY PROCEDURES: Remove powerplant (page 5-1) Remove engine oil filter vent bolt and sealing washer (page 6-128, step 1) Drain engine oil (2A engine, page 6-47) (2D engine, page 6-49) Loosen engine oil drain valve (page 6-128, 2D engine only, step 2) Disconnect and cover engine oil return hose and fitting (page 6-129, steps 3 and 4) Remove left side engine oil cooler when left thermostat is to be replaced (2A engine, page 6-121) (2D engine, page 6-128) Go on to Sheet 2 TA147607 6-158