TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 232 of 772
TM 9-2350-260-20-1-2 ENGINE OIL COOLER FLUID PUMP CONNECTOR REPLACEMENT (2D ENGINE) (Sheet 2 of 4) REMOVAL: 1. Using 9/16 inch wrench, remove vent bolt (A) and sealing washer (B). 2. Throw washer (B) away. 3. Using 3/4 inch wrench, loosen oil drain valve (C) six complete turns. 4. Using screwdriver and 3/8 inch wrench, remove clamp (D) on hose (E) If clamp is attached to hose. If clamp (D) i not attached to hose (E), go to step 5. 5. Using 1-1/2 inch wrench, remove fitting (F) from connector (G). 6. Using two 1-1/2 inch wrenches on hose (E) and fitting (H), remove hose (E). 7. Using 1/2 inch wrench, remove three self-locking nut (J) from connector (G). 8. Throw three nuts (J) away. 9. Remove connector (G). Go on to Sheet 3 TA147604 6-155